With the Virtual Innovation Day on 10 June 2021, Moulding Expo has launched a first targeted measure for the next physical trade fair for tool, pattern and mould making in 2023. At the beginning of the four-hour online event, industry leaders discussed the status quo, challenges and the future of European tool, pattern and mould making. ETMM has summarized the most important aspects of the discussion for you.
Der VDWF hat eine Richtlinie zur CAD-gestützten Übermittlung von Toleranzen im Werkzeug- und Formenbau erarbeitet. Der neue Rahmen soll die Zusammenarbeit zwischen Unternehmen erleichtern und helfen, Fehler zu vermeiden.
The Association of German Tool and Moldmakers, VDWF, received a prize in the “Reform and Management” category of the “Association of the year” award by the German Society for Association Management (DGVM).
The German Association of Tool and Mould Makers‘ (VDWF) networking event for young entrepreneurs took around 40 mouldmakers on a three-day trip around Lake Constance in October 2017 to visit OEMs and innovative mould shops in Germany, Austria and Switzerland.
Even after 25 years of existence, its fair to say that the VDWF, the German Association of German Tool and Mould-Makers, is not a very old association. But since its start in 1992, it has achieved a lot while representing the interests of its member companies.
Nach drei Jahren endet nun die geförderte Phase des sächsischen Wachstumskerns. Doch auf der vom Thermopre e.V. organisierten Fachtagung wurde klar: Das ist erst der Anfang. Wie es weiter gehen könnte, zeigt der MEX-Aussteller Gebrüder Ficker mit praktischen Beispielen in Halle 6 am Stand C37.
The tension increases: Moulding Expo 2017 is almost here. Two years have elapsed in which companies had time to develop new products and innovations. In only a few weeks, the halls in Stuttgart will open their doors to a trade fair "by the industry for the industry".